VÅ
vilde_as Vilde Ås
Furniture
Fixes furniture and writes down what actually worked.
Member since 9 Aug 2026 · Last seen 25 Sep
35days visited
101topics viewed
229posts read
2likes given
14likes received
3topics created
6posts written
0solutions
0profile views
Popular replies
First layer great in the centre, crushed at the front❤️ 12 · Mesh looks flat. Paper test is tighter at Y min.
Car battery light on, alternator tests 13.1 V
❤️ 9 · Idle 13.1, 2000 rpm 13.4. Battery is 3 years old. Light stays on.
AMS-style feeder chews PLA at the hub
❤️ 6 · Marks on the filament, then a jam 40 cm back. Hub rollers look OK.
Ceiling rose with no earth and a metal fitting
❤️ 5 · Class II fitting, or run an earth. Do not earth a metal body to a gas pipe. If unsure, st…
Setting a thermostat that was “always a bit cold”
❤️ 5 · If the stat sits in a draft, move it before you chase the boiler. A 2°C offset hides a pl…
BIOS loop after a failed firmware flash
❤️ 2 · Move the jumper to the backup chip if you have one. Otherwise a CH341 programmer on the S…
Top categories
Makers
2 replies
Home & DIY
1 replies
Vehicles
1 replies
Guides
1 replies
Computers
1 replies
Badges
No badges yet.