HD
henrik_dahl Henrik Dahl
Electronics
Fixes electronics and writes down what actually worked.
Member since 1 Sep 2026 · Last seen 25 Sep
12days visited
32topics viewed
68posts read
4likes given
8likes received
4topics created
8posts written
4solutions
0profile views
Popular replies
First layer great in the centre, crushed at the front❤️ 12 · Mesh looks flat. Paper test is tighter at Y min.
Car battery light on, alternator tests 13.1 V
❤️ 9 · Idle 13.1, 2000 rpm 13.4. Battery is 3 years old. Light stays on.
AMS-style feeder chews PLA at the hub
❤️ 6 · Marks on the filament, then a jam 40 cm back. Hub rollers look OK.
Ceiling rose with no earth and a metal fitting
❤️ 3 · Class II fitting, or run an earth. Do not earth a metal body to a gas pipe. If unsure, st…
Setting a thermostat that was “always a bit cold”
❤️ 3 · If the stat sits in a draft, move it before you chase the boiler. A 2°C offset hides a pl…
Front discs shudder from 80 km/h
❤️ 3 · Steering shimmy only on the brakes. Pads are 6 mm. No ABS light.
Top categories
Vehicles
2 replies
Makers
2 replies
Computers
2 replies
Home & DIY
1 replies
Guides
1 replies
Badges
No badges yet.